17
Insignia NS-MDDVD10 Dual-Screen Portable DVD Player
www.insignia-products.com
3 Press Pause to interrupt playback, and press
Play to resume playback.
Note:
• You also can press the GOTO function or use the
numbered buttons to enter a photo number and quickly
select any image.
• Press the Angle button on the remote control to rotate the
picture orientation by 90°.
Playable files
The ability of this unit to read MP3 discs is
dependent on the following:
• The bit rate must be from 64 to 256 kbps.
• The total number of files on the disc should
not exceed 254.
• The maximum number of directories should
not exceed 32.
• The maximum level of directories should not
exceed 4.
• File names should use 7 or fewer characters,
and must incorporate the “MP3” file
extension. For example: *******. MP3 where
each * is a letter or number.
• Use only letters and/or numbers in file
names. If you use special characters, the file
and/or folder names may not be displayed
correctly on the on-screen display.
• When recording on CD-R discs, use
74-minute (650 MB) discs.
• The CD-R or -RW discs should be finalized
on the computer using single session format
with recording speed less than 8x.
• See your CD/MP3 creation software for more
information.
Maintaining your DVD player
Cleaning the player
• Wipe with a soft cloth. If the player is very
dirty, dampen the cloth with a weak solution
of neutral detergent and water, and then wipe
clean. Do not use compressed air to remove
dust.
Caring for discs
• Do not touch the surface of the unlabeled
side of the disc.
• Do not stick paper or tape on the surface of
the disc.
• Do not expose the disc to direct sunlight or
excessive heat.
• Do not use irregularly shaped discs (for
example: heart shaped or octagonal). They
may cause malfunctions.
Cleaning discs
A dirty disc causes sound skipping, and if the
disc is very dirty, the disc may not work at all.
Hold the disc by its inner and outer edges.
• Fingerprints and dust should be carefully
wiped from the surface of the DVD or CD with
a soft cloth. Wipe in a straight motion from
the center to the edge.
• Never use thinner, benzine, record cleaner,
or anti-static spray on a DVD or CD, because
they can damage its plastic surface.
Note:
Before transporting the unit, remove any disc from the disc
compartment.
Troubleshooting
Problem Solution
No power • Check that the AC power cord or the
DC power cord is connected.
• Make sure that the unit is turned on.
The remote
does not work
• Remove any obstacles between the
remote and the unit.
• Use the remote near the unit.
• Point the remote at the remote sensor
on the unit.
• Replace the battery in the remote with
a new one.
DVD has little
or no sound
• Make sure that you have selected DVD
mode.
• The system is in pause mode. Press
PLAY to return to normal play mode.
• DVD is in fast forward or fast reverse
mode. Press PLAY to return to normal
play mode.
• Make sure that AUDIO/VIDEO output
connections are correct.
• The DTS DVD disc cannot be decoded
for speaker output.
• This unit is too hot. Turn off the DVD
player and allow for it to cool for 30
minutes.
No picture The region number of the disc doesn't match
the region number of this unit.
The picture is
not clear
The disc is scratched. Clean the disc.
Severe hum or
noise is heard
• The plugs and jacks are dirty. Wipe
them with a cloth slightly moistened
with alcohol.
• Clean the disc.
The disc does
not play
• There is no disc inside (No Disc
appears on the screen). Insert the disc
correctly.
• Clean the disc.
• A non-NTSC disc has been inserted.
The unit and disc region number are
incompatible.
• Condensation may have formed inside
the unit due to a sudden change in
temperature. Wait about an hour for
the condensation to clear and try
again.