Filter
Top Products
COPYING A VIDEO TAPE
48
COPYING A VIDEO TAPE
Connect the editing (recording) VCR, source (playing) VCR and your TV using the
following diagram.
EXAMPLE: The editing (recording) VCR is this unit. The source (playing) VCR is
another VCR.
1) Insert a pre-recorded video cassette into the source (playing) VCR.
2) Insert a blank video cassette, or one you want to record over, into the editing
(recording) VCR cassette compartment.
3) Press TAPE SPEED button on the remote control to selec the desired recording
speed (SLP, LP or SP) on the editing (recording) VCR.
4) Select AUX position on the editing (recording) VCR. See page 11, under "Input
Select".
5) Press REC button on the editing (recording) VCR.
6) Begin playback of the tape in the source (playing) VCR.
NOTES:
• For best results during dubbing, use the VCR's front panel controls whenever possible.
The remote control might affect the playback VCR's operation.
• Always use video-quality shielded cables with RCA-type connectors. Standard audio
cables are not recommended.
• You can use a video disc player, satellite receiver, or other audio/video component with
A/V outputs in place of the playback VCR.
TO MONITOR THE RECORDING
1) Turn on the TV, and set it to the same output channel as the editing VCR channel 3
or 4.
2) Press VCR/TV button on the remote control so that "VCR" appears on the display.