Filter
Top Products
TIMER RECORDING
46
If you want to correct an automatic timer after you finished setting program,
1) Repeat steps [1] to [3] on previous page.
2) Select a digit you want to change using SELECT button or ADD/DELETE button.
3) Enter correct numbers using CH/SET or button.
4) Press MENU button to return to original mode.
5) Press POWER button to return to timer stand-by mode.
TO STOP AN AUTOMATIC TIMER PROGRAM WHICH HAS ALREADY
STARTED
Press STOP/EJECT button on the VCR.
NOTE: STOP button on the remote control will not function in the Automatic Timer
Recording mode.
TO CANCEL OR CHECK THE START/END TIME
1) Repeat steps [1] to [2] previous page.
2) Select a program number you want to check using CH/SET or button. The
details of selected program appears on the TV screen.
You may cancel the entire program by pressing ADD/DELETE button.
HINTS FOR TIMER RECORDING
• If there is a power failure or the VCR is unplugged for more than 30 seconds, the clock setting
and all timer settings are lost.
• If the tape runs out before the end time, the VCR will switch to the Stop mode immediately,
eject the tape and the VCR power will be turned off. The "
" indicator will flash.
• If a tape is not inserted or the erase-protection tab is removed, the "
" indicator flashes and
automatic timer recording cannot occur. Insert a tape that allows recording.
• The TV that is connected to your VCR may be turned ON or OFF when the VCR is in the
timer-record mode.
• When you record a cable channel program with cable converter box, first set the VCR's
channel to 3 or 4 whichever is the output channel of your cable box to the channel you want to
record and leave on while you are recording with power on.
AUTO RETURN
If you select auto return to [AUTO] from the menu, when all the timer recordings are
completed, the VCR will return to the beginning of the recorded program(s).
NOTE: If there are any remaining programs including Daily & Weekly, this function does