Filter
Top Products
Getting Started (Controls)
20
Getting Started (Controls cont.) pg. 16
Remote Control Buttons
Remote Control Illustration
POWER Turns the VCR on and off.
VCR1, TV, CATV, VCR2 Device buttons let you set the remote to control one of four devices.
MUTE (TO CONTROL TV) Turns off the audio until you press Mute again.
VOLUME/SLOW Increase or decrease the audio volume and plays back in adjustable slow motion.
REW Rewinds the videotape.
PLAY Starts playing a loaded videocassette.
STOP Stops a videocassette from playing, recording, pausing, rewinding - or anything it is doing.
GUIDE Brings up an on-screen setup and programming guide, the Easy Graphic Menu.
TAPE SPEED Switches between standard play (SP) and extended play (EP).
AVX Used for recording from an auxiliary input such as a stereo system.
INDEX Used for marking and searching for specific tape locations.
LAST CHANNEL (TO CONTROL TV) Switches to the channel you watched previously during the current
viewing session.
CHANNEL Top button switches to the next higher channel, bottom button switches to the next lower
channel. For these to operate, you must have preset your channels.
REC Starts recording on the station the VCR is set to. (Press REC and PLAY at the same time.)
F.FWD Fast forwards the videotape.
PAUSE Temporarily stops the cassette from recording or playing. Press PAUSE again (or PLAY) to
resume.
F.ADV Lets you advance the tape frame by frame.
CLEAR Used in on-screen programming and indexing.
DISPLAY Used in on-screen programming and indexing.
TRACKING Lets you fine tune the picture.
0 to 9 Number buttons used in on-screen programming. Can also be used to change channels. (Simply
press 2 or 3 digits for the channel you want - such as 0 and 6 for channel 6, or 100/ENT and 2 and 4 for
channel 124.)
VCR/TV Switches between viewing through the VCR and not viewing through the VCR.