Filter
Top Products
Getting Started
14
Getting Started (Hookups cont.) pg. 11
If you have been watching the TV in your home before getting the VCR, you will already have a round
wire attached to your TV. Otherwise, look for a cable connection coming in through the wall from outside.
(If you find this connection, remember to call your local cable company to start the service.)
1. If still hooked up to your TV, unscrew the round wire from the 75 ohm connector on your television.
Otherwise, take the wire that comes in from the wall.
2. Screw this round wire into the IN FROM ANT jack on the back of your VCR.
3. Using the 75 ohm cable supplied with your VCR, slide on either end to the OUT TO TV jack on the
back of the VCR.
4. Connect the other end of the same cable onto the 75 ohm antenna input on your TV (where you first
disconnected the TV in step 1.)
Capabilities: With this hookup, you should now be able to perform all the basic functions provided by this
equipment.