Filter
Top Products
Getting Started
13
Getting Started (Hookups cont.) pg. 10
Connect the yellow VIDEO OUT jack on the VCR to the VIDEO IN jack on the TV.
This direct video input will give you the best picture. It will also let you play videos in a "picture in picture"
feature, if your TV has it.
Then connect the AUDIO OUT jacks (red and white) on the VCR to the AUDIO IN jacks on the TV (left
to left, right to right).
This audio hookup will give you better sound than the RF signal hookup, because the electronic signal
won't have to go through a conversion process.
Plus your VCR has a stereo decoder, which your TV might not. For big speaker sound, you can also use
these jacks to connect the VCR to your stereo system (page 46).
Capabilities: The audio and video signal connections are all you need to play back a prerecorded tape. If
you do not intend to record on your VCR from your antenna/cable, then you're all hooked up now.
Otherwise, continue with Step 4, which will let you record off TV channels.
4 Hook Up the RF Signal
Look at the back of your TV for a connector that looks like one of these, and follow the
corresponding hookup option. If you have any sort of cable box, see the hookup options in Advanced
Operations (page 42).
Simple Antenna/Cable 75 Ohm Hookup
This is an easy hookup that you can use if your cable or antenna has a 75 ohm round wire connector.
You will need the 75 ohm cable supplied with your VCR. It looks like this: