Filter
Top Products
Getting Started
16
Getting Started (Hookups cont.) pg. 13
If you have "rabbit ears" (an antenna on top of your TV), you will need an additional adapter and 75 ohm
extension to make your leads reach from the antenna to the VCR. This connection will work only if you
have a strong, clear picture on the TV, indicating a strong signal. Connect the antenna to the adapter,
and use the cable extension to go from the adapter to the VCR. Use the supplied 75 ohm cable to
connect the VCR to the TV.
Now continue with the hookup:
1. Using whichever adapter you have fit your antenna with, attach that connector to the IN FROM ANT
jack on the back of the VCR.
2. Using the 75 ohm cable supplied with your VCR, connect either end to the OUT TO TV jack on the
back of the VCR.
3. Use a second adapter to attach the other end of the 75 ohm connector back into the TV (where you
first disconnected the antenna).
Capabilities: With this hookup, you should now be able to perform all basic functions provided by this
equipment.
5 Attach the TV and VCR to the Power Supply
Plug in the TV and VCR power cords to the wall outlet or an appropriate extension cord or surge
protector. See Important Safeguards for further precautions (page 6).