Filter
Top Products
HP P2000 G3 SAS MSA System User Guide 39
Four servers/one HBA per server/dual path
Connecting remote management hosts
The management host directly manages systems out-of-band over an Ethernet network.
1. Connect an RJ-45 Ethernet cable to the network management port on each P2000 G3 MSA System
controller.
2. Connect the other end of each Ethernet cable to a network that your management host can access
(preferably on the same subnet).
NOTE: Connections to this device must be made with shielded cables – grounded at both ends – with
metallic RFI/EMI connector hoods, in order to maintain compliance with FCC Rules and Regulations.
Updating firmware
After installing the hardware and powering on the storage system components for the first time, verify that
the controller modules, expansion modules, and disk drives are using the current firmware release. Using
SMU, right-click the system in the Configuration View panel, and select Tools > Update Firmware. The
Update Firmware panel displays the currently installed firmware versions, and enables you to update them.
NOTE: To locate and download the latest software and firmware update for your product, go to
http://www.hp.com/go/p2000
. Select Models — select your product — select HP Support & Drivers,
then select Download drivers and software.
6Gb/s
6Gb/s
Server 1 Server 2
Server 3 Server 4