Filter
Top Products
56 Presenting Through a Wireless Network
3. Make sure Location is set to
Automatic.
4. Select
Network Port Configurations in the Show pull-down
menu.
5. Under Port Configurations, select
AirPort.
6. Click
Apply Now. Then close the window.
7. Click the AirPort icon on the menu bar at the top of the Mac
desktop. You see the AirPort status menu:
8. Check to make sure AirPort is turned on.
9. Select your projector’s ESSID.
note:
If you don’t need the other
network port
configurations, disable
them by deselecting their
checkboxes.
When you connect in Ad
Hoc mode, your computer
is disconnected from any
other wireless networks. If
you need to remain
connected to your wireless
network, use Access Point
mode, as described on
page 57. Also, make sure
you reconnect to your
original wireless network
when you are done using
the projector.
Select
Automatic
Select Network Port
Configurations
then select AirPort
Choose the ESSID
you assigned to the
projector