Directed Electronics OHDW17.2 Portable DVD Player User Manual


 
© 2005 Directed Electronics—all rights reserved
MENU (CONSOLE MENU)
Press "MENU" button on the monitor or remote to activate the screen parameters set-up. The
sequence of set-up items is as follows:
FM: Transmitting frequency SHARPNESS: Sharpness adjustment
BRIGHTNESS: Brightness adjustment CONTRAST: Contrast adjustment
SATURATION: Color saturation adj. HUE: Color hue adjustment
RESET: Resets above (except FM) to factory default settings.
Once the desired setting is selected, press the cursor buttons to adjust the setting. On the remote
use the up/down cursor buttons located at either side of the menu button. On the monitor use the
cursor buttons to the right side of the button. If a button is not activated within 5 seconds,
this function mode will turn OFF. Once the correct function is selected, press the cursor button (to
set the desired setting). If no button is pressed, the menu mode will turn OFF in about 5 seconds.
The FM frequency setting allows the monitor to transmit audio to the vehicle’s radio. Use a frequency
that is not interfered with from a local broadcast station. This setting also has an OFF position.
DOOR LIGHT ON/OFF
Engage this switch on the monitor to activate the dome lights when a door is open.
NOTE: This function is operational only when the Gray wire of the dome light circuit
is connected to the door switch.
COURTESY LIGHT ON/OFF
Activate this switch on the monitor to control the dome light illumination.
FM SHARPNESS BRIGHTNESS CONTRAST
SATURATION HUE RESET
22