Filter
Top Products
11
4. Adjust the car mount
for the best viewing angle.
5. After setting up the device on the car mount, connect the car charger.
If the car engine is turned off, you may be required to switch the vehicle ignition
back into the Accessories position. Consult your vehicle owner’s manual.
e. Connect the car charger to the power connector on the cradle.
f. Plug the other end of the car charger to your vehicle’s cigarette
lighter.
g. The power LED indicator lights up orange during charging. The hot
keys backlight is also lit up.
Start up the NAV 350
After mounting the NAV 350 on a vehicle it is ready to be used. Turn it on to
calibrate the screen. After screen calibration, proceed to system settings
configuration.
To turn on and calibrate the device:
Turn on the device by pressing the power button
on the top right
panel of the device. The Main Menu panel displays. This is also referred to
as the Home panel.
The device comes with the battery pre-charged to at least 30% capacity. You can
start using it once it is mounted in your vehicle and connected to the cigarette
lighter. However, for maximum usage time you need to charge your device to full
capacity. Go to the “Recharging the device
” section for instructions.