Filter
Top Products
ENGLISH
Getting Started Connections Playback Information Troubleshooting Specifications
Setting items Setting contents
Party Mode
Function
Set the Party Mode
function.
ON : Enable Party Mode function.
OFF : Disable Party Mode function.
Refer to page 30, “Playing the Same Network
Audio on Different Devices Connected in a Network
(Party Mode Function)” for more information on the party
mode function.
Party Start Level
Make settings for
volume level when
the Party Mode is
started.
Volume Level
0 ~ 100 % : Start party mode with your preferred volume.
This can be set when “Party Mode Function“ is set
to “ON“.
•
Firmware Update
Update the firmware.
Check for Update : You can update to the latest firmware
by connecting the ASD-51W to a network.
It is recommended that you update to the latest firmware
version when using the ASD-51W.
NOTE
When you update the firmware your settings will be
returned to the default values. Please be aware that
updating the firmware will erase all your settings,
including the stations registered in your Favourites
and your Recently Played list.
GHow to update the firmwareH
1. Connect the monitor and connect to the network.
(
vpage 6)
2. Turn on the ASD-51W (vpage 4, 6 b1 ).
3. Configure the network connection settings.
(
vpage 7)
Making Detailed Settings (Setup)
Setting items Setting contents
Firmware Update
(Continued)
4. While watching the GUI screen, use uio p to
select “Setup” – “Other” – “Firmware Update”.
When the language setting is “English”.
5. Select “Start” and press ENTER.
When you press ENTER, firmware updating starts
automatically.
The message “Now Updating. During this process
screen will go blank for several minutes. Do not turn
off.” will appear briefly, after which the GUI screen
will go blank.
During firmware updating, the power indicator is
turned off and the GUI screen is blank.
The updating process takes approx. 10 ~ 15 minutes
with a broadband connection. The actual time will vary
depending on the server status and the speed of the
Internet.
When updating is complete, the GUI screen reappears
automatically.
Set the power operation switch on the ASD-51W to
“OFF”. Firmware updating is now complete.
NOTE
Step 5 cannot take place if the ASD-51W does not
connect to the Internet. In this case, repeat the procedure
from step 2.
If your ASD-51W already has the latest firmware
version, the message “Latest Firmware” will appear
at step 5. In this case, you do not need to update the
firmware.
b
•
•
•
•
•
•
Setting