Filter
Top Products
ENGLISH
Getting Started Connections Playback Information Troubleshooting Specifications
Making Detailed Settings (Setup)
Setting items Setting contents
Network Setup
(Continued)
y Use uio p to input the proxy server port number
and press ENTER.
u Use i to select “Exit” and press ENTER.
Setup is complete.
When searching
access points
to connect
automatically, refer to
“Automatic settings”.
When searching
access points to
connect manually,
refer to “Manual
settings”.
If the device is
connected to a router
with a WPS function,
please refer to “WPS
settings”.
Wireless LAN settingsn
1. Fitting a rod antenna (vpage 7).
If a LAN cable is connected, remove it.
2. Turn on the ASD-51W (vpage 4, 6 b1 ).
3. Set the access point at the GUI menu “Setup”
– “Network” – “Network Setup”.
b
Automatic settings
Network Setup
Up/Down Back/Select
WPS
Search
Manual
Search
Up/Down Back/Se lect
SSID_2
Search
SSID_3
SSID_4
SSID_5
75%
90%
50%
30%
10%
WEP
WEP
WEP
None
None
SSID_1
q Select “Search” and press ENTER.
The access point you have set is displayed.
If your preferred access point is not found, repeat
step q.
b
Setting items Setting contents
Network Setup
(Continued)
w Use ui to select the access point, and then press
ENTER.
If the access point is not detected automatically,
use the “Manual settings” procedure (vpage
15).
If the access points are repeat search, use i to
select the “Search” and press ENTER.
e If there is an encryption setting for the access point
you selected in step w, enter same encryption key
as used for the access point. (If there is no encryption
setting, proceed to step r.
Use uio p to input the “Key” (encryption key) and
press ENTER. Enter the same encryption key as used
for the access point.
The types of characters that can be input are as shown
below.
GLower case charactersH a ~ z
GUpper case charactersH A ~ Z
GSymbolsH ! “ # % & ’ ( ) * + , - . / : ; < = > ? @ [
\ ] _ (Space)
GNumbersH 0 ~ 9
When no security settings have been used in
the Internet connection settings, this step is not
necessary.
When connecting to a “WEP” encrypted network,
set the access point “Default Key” to “1”.
r Use i to select “Connection” and press ENTER.
Network connection starts.
ASD-51W performs automatic network setup due to
the DHCP function.
When connecting to a network that has no DHCP
function, perform the setting in step 4.
4. Set the IP address
(vpage 11 “Wired LAN settings”
– step 3 – e).
b
b
•
b
b
b
See overleaf
q
w
Setting