A SERVICE OF

logo

Printer Basics
Load Roll Media
Z4Mplus and Z6Mplus User Guide 47
11. Pull down the peel lever to open the peel assembly.
12.Feed the media over the tear-off/peel-off bar, and through the slot in the peel
assembly.
13.Loosen the thumbscrew and slide out the rewind media guide to the end of the
take-up spindle.
14.Slide an empty core onto the take-up spindle; wrap the liner around the core and
turn the take-up spindle counterclockwise to wind up the excess liner.
15.Slide the rewind media guide against the liner and tighten the thumbscrew.
16.Close the printhead assembly.
17.Close the peel assembly using the peel lever.
18.If the printer is paused (the Pause light is on), press PAUSE to enable printing.
Peeling starts automatically. Press FEED to test.
Note • The liner must be attached to the take-up spindle for the printer to operate
properly. Ensure the edge of the liner is flush against the backplate of the take-up
spindle.