Printer Setup
Basic Configuration
Z4Mplus and Z6Mplus User Guide 25
If the label liner has black marks, continue with Step 24.
24.Press SELECT.
25.Press PLUS (+) or MINUS (–) to scroll through the setting options. Stop at the
setting that matches your printer options (Web or Mark).
26.Press SELECT to accept the change.
27.Press PLUS (+) to move to the next option.
SENSOR SELECT displays.
Auto Select is the default setting. Do not make any changes.
28.Press PLUS (+) to move to the next option.
PRINT METHOD displays.
• Use Thermal Transfer if you are using ribbon with your label material.
• Use Direct Thermal if you are not using ribbon. Direct thermal label media
has ink embedded in the label material that is brought out by the heat of the
printhead.
If the Print Method setting matches your media and ribbon choices, press
SETUP/EXIT to leave the front panel menu,
SAVE CHANGES PERMANENT displays.
29.Press SETUP/EXIT again.
30.SAVING PERMANENT displays. One or more labels may feed out, depending on
your setting choices.
The LCD displays PRINTER READY.
If the Print Method setting does not match your media and ribbon choices, follow the
steps below.
31.Press SELECT.
32.Press PLUS (+) or MINUS (–) to scroll through the setting options. Stop at the
setting that matches your printer options (Thermal Transfer or Direct Thermal).
33.Press SELECT to accept the change.
34.Press SETUP/EXIT to leave the front panel menu.
SAVE CHANGES PERMANENT displays.
35.Press SETUP/EXIT again.
SAVING PERMANENT displays. One or more labels may feed out, depending on
your settings. The LCD displays PRINTER READY.
