A SERVICE OF

logo

112 Z4Mplus and Z6Mplus User Guide
Troubleshooting
Printer Diagnostics
Communications Diagnostics Test
This test is controlled from the front panel display. See page 75. A typical printout
from this test is shown in below. Turn the printer Off (O) to exit this self test.
Loading Factory Defaults
Perform the following procedure to load the factory defaults:
1. Press SETUP/EXIT two times.
2. Use PLUS (+) or MINUS () to scroll through the SAVE CHANGES choices.
3. When LOAD DEFAULTS displays, press SETUP/EXIT.
Note • This label is inverted when printed (prints upside down).