Configuration
Overview
11342L Re v. 8 6/4/2004 105SL User Guide 43
Exit Setup Mode
To leave Setup Mode, complete these steps:
1. Press SETUP/EXIT.
The LCD displays
SAVE CHANGES
.
2. Press the Plus (+) or Minus (–) to display the save options (Table 4).
3. Press NEXT/SAVE to sele ct the displayed choice.
When the configuration and calibration sequence is done,
PRINTER READY
displays.
Table 4 • Save Options When Leaving Setup Mode
LCD Display Description
PERMANENT
Permanently saves the changes. Values are stored in the printer even when
power is turned off.
TEMPORARY
Saves the changes until you change them again or until power is turned off.
CANCEL
Cancels all changes from the time you pressed SETUP/EXIT except the
darkness and tear-off settings (if they were changed).
LOAD DEFAULTS
Sets all parameters other than the network settings back to the factory defaults.
Note • Loading factory defaults causes the printer to auto-calibrate.
LOAD LAST SAVE
Loads values from the last permanent save.
DEFAULT NET
Sets the wired and wireless netwo rk settings back to facto ry defau lts.
