Troubleshooting
LED Error Messages
11342L Re v. 8 6/4/2004 105SL User Guide 81
Warning—
Head Too Hot
The printhead is over
temperature.
Allow the printer to cool. Printing automatically
resumes when the printhead elements cool to an
acceptable operating temperature.
Warning—
Head Cold
The printhead is under
temperature.
Continue printing while the printhead reaches the
correct operating temperature. If the error remains,
the environment may be too cold for proper
printing. Relocate the printer to a warmer area.
Printhead data cable is not
properly connected.
The printhead can be very hot and can cause severe
burns. Allow the printhead to cool.
Disconnect and reconnect data ca ble to the
printhead. Ensure that the cable connector is fully
inserted into the printhead connector.
Warning—
Cutter Jammed
Cutter blade is in the media path. Turn off the printer power and unplug the printer.
Inspect the cutter module for debris and clean as
needed following the cleaning instructions on
page 75.
Out of Memory
There is not enough memory to
perform the fu nction shown on
the second line of the error
message.
Insufficient memory for the label length,
downloaded fonts/graphics, and images.
Ensure that the device, such as Flash memory or
PCMCIA card, is installed and not write-protected
or full.
Ensure that the da ta is not directed to a devic e that is
not installed or available.
Table 11 • LCD Error Messages (Continued)
LCD Possible Cause Recommended Solution
