SECTION 9—FRONT RIGGINGS
Part No. 1122145 63 Pronto® M94™
FIGURE 9.6 Adjusting/Replacing Telescoping Front Rigging Supports - Van Style Seats
Adjusting/Replacing Telescoping Front Rigging
Supports - ASBA
NOTE: For this procedure, refer to FIGURE 9.7.
1. Remove the two mounting screws, spacers and locknuts that secure the telescoping
front rigging support to the seat frame.
2. Perform one of the following:
A. Slide existing telescoping front rigging support to one of three depth positions.
B. Remove existing telescoping front rigging.
3. Secure telescoping front rigging at desired depth with existing two mounting screws,
spacers, and locknuts. Securely tighten.
NOTE: The two telescoping front rigging supports can be positioned at different depths depending
on the need of the user.
STANDARD POSITION 1-INCH OUT 2-INCHES OUT
18 & 20-Inch
Wide
22 & 24-Inch
Wide
18 & 20-Inch
Wide
22 & 24-Inch
Wide
18 & 20-Inch
Wide
22 & 24-Inch
Wide
Holes 2 and 3 Holes 4 and 5 Holes 3 and 4 Holes 5 and 6 Holes 4 and 5 Holes 6 and 7
Hinge
Pins
Spacer
Telescoping Front
Rigging Support
Mounting
Holes
Locknuts
Mounting Bolts
Seat Frame
Not Used
Inner Mounting
Holes
2
Not Used
4
3
5
7
8
6
