SECTION 9—FRONT RIGGINGS
Part No. 1122145 59 Pronto® M94™
SECTION 9—FRONT RIGGINGS
ƽ WARNING
After ANY adjustments, repair or service and before use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
DO NOT stand on the front riggings, otherwise damage may occur. When getting
in or out of the wheelchair, make sure that the footplates on the front riggings are
in the upward position or moved out of the way.
While the wheelchair is moving, minimum ground clearance for the front rigging is
three inches. If the wheelchair is not moving, the front rigging MUST maintain a
minimum of one inch ground clearance - otherwise personal injury and damage may
result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the Off position.
Installing/Removing Front Riggings
CAUTION
If front riggings are used, then the seat MUST be adjusted to the highest mounting
position - otherwise damage may occur.
NOTE: For this procedure, refer to FIGURE 9.1.
Installing
1. If necessary, remove the footboard.
Refer to Removing/Installing the
Footboard Assembly on page 56.
2. Turn front rigging to the side (open
footplate is perpendicular to
wheelchair) and position mounting
holes in the front rigging hinge plates
with hinge pins on the wheelchair
frame.
3. Install the front rigging hinge plates
onto the hinge pins on the wheelchair
frame.
FIGURE 9.1 Installing/Removing Front
Riggings
4. Push the front rigging towards the inside of the wheelchair until it locks into place.
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
5. Repeat STEPS 1-4 for opposite side of wheelchair.
Telescoping
Front Rigging
Support
Front Rigging
Release Lever
Front Rigging
Hinge Plate
Hinge
Pins
