SECTION 9—FRONT RIGGINGS
Part No. 1122145 61 Pronto® M94™
3. Securely tighten the lug bolt and locknut that secure the lower footrest to the footrest
support.
4. Repeat STEPS 1-3 for the opposite side of the wheelchair footrest, if necessary.
Replacing Heel Loops
NOTE: For this procedure, refer to FIGURE 9.4.
1. Note the position of hex bolt, coved
washers and locknut for reinstallation.
2. Remove the hex bolt, coved washers
and locknut that secure the lower
footrest to the footrest support.
3. Remove the lower footrest.
4. Remove the phillips bolt, spacer and
locknut that secure the existing heel
loop to the lower footrest.
5. Slide the existing heel loop off the
lower footrest.
6. Replace heel loop.
7. Reverse STEPS 1-6 to reassemble.
FIGURE 9.4 Replacing Heel Loops
NOTE: When securing heel loop to lower footrest, tighten the phillips screw and locknut until the
spacer is secure.
Raising/Lowering Elevating Front Riggings
NOTE: For this procedure, refer to FIGURE 9.5.
1. Perform one of the following:
• Raising - Pull back on the release
lever and raise front rigging to the
desired height.
• Lowering - Support front rigging
with one hand away from the
release lever. Push release lever
downward with other hand.
FIGURE 9.5 Raising/Lowering Elevating
Front Riggings
Adjusting/Replacing Telescoping Front Rigging
Supports - Van Style Seats
NOTE: When adjusting the telescoping front rigging support depth, ensure the footplate does not
interfere with the caster wheel rotation.
Coved
Washer
Hex Bolt
Footrest
Support
Coved
Washer
Locknut
Lower
Footrest
Phillips Bolt
Locknut
Spacer
Heel Loop
Release
Lever
