SECTION 6—ARMS
Pronto® M94™ 46 Part No. 1122145
3. Lock top of flip back armrest by pushing height adjustment lever into the Down
(vertical) position.
4. Lift up on flip back armrest to make sure the armrest is locked in place.
5. Repeat STEPS 1-4 for opposite flip back armrest, if necessary.
FIGURE 6.2 Adjusting Flip Back Armrests
Adjusting Van Seat Armrests
Angle
ƽ WARNING
Pinch point may occur when adjusting the arm angle position.
NOTE: For this procedure, refer to Detail “A” of FIGURE 6.3 on page 47.
1. Lift up the armrest.
2. Loosen the jam nut.
3. Adjust the socket screw up or down to the desired arm angle position.
4. Tighten the jam nut.
5. To determine the same angle for the opposite armrest, count the exposed threads after
the jam nut has been tightened.
6. Repeat STEPS 1-4 for opposite armrest, if necessary.
Height
NOTE: For this procedure, refer to Detail “B” of FIGURE 6.3 on page 47.
1. Remove the socket screw that secures the armrest to the seat frame assembly.
2. Adjust the armrest to one of four positions.
3. Reinstall the socket screw that secures the armrest to the seat frame assembly and
tighten securely.
Locked
(Down - Vertical)
Unlocked
(Up - Horizontal)
Flip Back Armrest
Release Lever
Flip Back
Armrest
Front Arm Socket
Height
Adjustment
Lever
