35
TONE SQUELCH AND POCKET BEEP
New2001
8
■ Tone/DTCS squelch operation
The tone or DTCS squelch opens only when receiving a sig-
nal with the same pre-programmed subaudible tone or DTCS
code, respectively. You can silently wait for the specified sig-
nal using the same tone.
qSet the desired frequency in FM mode.
wPush [TS•SET] for 1 sec. to enter set mode.
eRotate [DIAL] to select “EXPAND” item.
rWhile pushing [FUNC], rotate [DIAL] to turn the expanded
set mode ON.
tRotate [DIAL] to select “TSQL” item.
yWhile pushing [FUNC], rotate [DIAL] to select the desired
subaudible tone condition from “TSQL,” “P BEEP,” “DTCS,”
“P DTCS” and “OFF.”
uPush [TS•SET] to exit set mode.
• One of “TSQL,” TSQLS,” “DTCS” or “SDTCS” appears ac-
cording to the tone selection in the step y.
iWhen a signal with the matched tone is received, the
squelch opens and the receiver emits audio.
When pocket beep function is activated, the receiver also
emits beep tones and blinks “S”.
• Beep tones sound and “S” blinks for 30 sec.
oPush [FUNC] to stop the beeps and blinking manually.
•“S” disappears and the pocket beep function is deactivated.
!0To cancel the tone squelch or DTCS, select “OFF” with the
“TSQL” item in the expanded set mode, as described in the
step y.
FM SQL SKIPTP FM SQL SKIPTP
FM DTCS SKIPP FM DTCS SKIPP
Tone squelch selection
Tone squelch with pocket
beep function selection
DTCS selection DTCS with pocket beep
function selection
Tone squelch selection
Tone squelch with pocket
beep function selection
DTCS selection DTCS with pocket beep
function selection
IC-R5_1.qxd 02.10.23 11:29 Page 35 (1,1)
