24
5
MEMORY CHANNELS
New2001
5
■ Erasing/transferring bank contents
Contents of programmed memory channels can be or trans-
ferred to another memory.
INFORMATION: Even if the memory bank contents are
cleared, the memory channel contents still remain pro-
grammed.
qSelect the desired bank contents to be transferred or
erased from the bank.
➥ Push [V/M•S.MW•~] to select memory mode.
➥ While pushing [BAND• ], rotate the [DIAL] to select
the desired memory bank group.
➥ Rotate [DIAL] to select the bank channel.
• Bank initial stops blinking.
• Select the bank channel with [BAND• ] and [DIAL], if de-
sired.
• Bank initial blinks.
wPush [V/M•S.MW•~] for 1 sec. to enter select memory
write condition.
• 1 short and 1 long beeps sound.
• Displays the original memory channel number automatically and
“” indicator and memory channel number blink.
• Do not hold [V/M•S.MW•~] for more than 2 sec. otherwise the
bank contents will be copied to VFO.
eWhile pushing [MODE•SCAN], rotate [DIAL] to select
“BANK” item.
• Pushing [MODE•SCAN] several times, “BANK” item is also se-
lectable.
rWhile pushing [BAND• ], rotate [DIAL] to select the de-
sired bank group to be transfer.
• Select “-- -- -- --” indication when erasing the contents from the
bank.
tRotate [DIAL] to select the desired bank channel.
yWhile pushing [MODE•SCAN], rotate [DIAL] to select
“S.MW” item.
• Pushing [MODE•SCAN] several times, “S.MW” item is also se-
lectable.
uPush [V/M•S.MW•~] for 1 sec.
When transferring When erasing
FM DUP SQLTFM DUP SQLT
Push for 1 sec.
IC-R5_1.qxd 02.10.23 11:29 Page 24 (1,1)
