27
6 SCAN OPERATION
New2001
■ Scan edges programming
Scan edges can be programmed in the same manner as
memory channels. Scan edges are programmed into scan
edges, 00A/00B to 24A/24B, in memory channels.
qPush [V/M•S.MW•~] to select VFO mode.
wSet the desired frequency:
➥ Select the desired band with [BAND• ].
➥ Set the desired frequency with [DIAL].
➥ Set other data
(e.g. offset frequency, duplex direction, tone
squelch, etc.), if desired.
ePush [V/M•S.MW•~] for 1 sec. to select select memory
write condition.
• 1 short and 1 long beeps sound.
•“ ” indicator and memory channel number blink.
rRotate [DIAL] to select the desired programmed scan edge
channel from 00A to 24A.
tPush [V/M•S.MW•~] for 1 sec.
• 3 beeps sound
• The other scan edge channel “B,” 00B to 24B, automatically se-
lected when continuing to push [V/M•S.MW•~] after program-
ming.
yTo program a frequency for the other pair of scan edges,
00B or 24B, repeat steps w and r.
• If the same frequency is programmed into a pair of scan edges,
programmed scan will not function.
[EXAMPLE]: Programming 145.300 MHz into scan edges 03A.
FM SKIPP FM FM SKIPPFM SKIPP
Push for 1 sec. Push for 1 sec.Rotate
IC-R5_1.qxd 02.10.23 11:29 Page 27 (1,1)
