29
6 SCAN OPERATION
New2001
■ Auto memory write scan
This scan is useful for searching a specified frequency range
and automatically storing busy frequencies into memory
channels. The same frequency ranges used for program scan
are used for auto memory write scan.
qSelect VFO mode with [V/M•S.MW•~].
wPush [MODE•SCAN] for 1 sec. to enter scanning type se-
lection condition.
eRotate [DIAL] to select the desired scanning type.
•“ALL” for full scan; “BAND” for band scan, “PROGxx” for pro-
grammed scan (xx= 0 to 24; programmed scan edges numbers
only displayed)
rPush [MODE•SCAN] to start the scan.
tPush [V/M•S.MW•~] to turn the automatic memory write
function ON and OFF.
•“ ” indicator blinks.
yPush [MODE•SCAN] to stop scan.
DD
During auto-memory write scanning:
• When signal is received, scan pauses and the frequency is
stored into auto memory write channel group (
R
000–
R
199).
- 2 short beeps sound when stored.
• Scan resumes after frequency storing.
• When all channels are stored, the scan cancels automati-
cally and 1 long beep sounds.
DD
Re-calling the stored frequencies:
qPush [V/M•S.MW•~] to select memory mode.
wPush [BAND• ] several times, or while pushing
[BAND• ], rotate [DIAL] to select the auto memory write
channel group.
•“R” appears.
eRotate [DIAL] to select the desired channel.
DD
Clearing the stored frequencies:
qSelect the auto memory write channel group.
wWhile pushing [FUNC], push [V/M•S.MW•~] for 1 sec. to
clear the all channels contents.
• 1 short and 1 long beeps sound.
NOTE: The auto memory write channel contents CANNOT
be cleared by an independent channel. Thus it is good idea
to copy the contents into regular memory channel.
FM
R
“R”
appears when auto memory
write channel group is selected.
FM SKIPP
[V/M•S.MW•~]
[MODE•SCAN]
[DIAL]
• During auto memory
write scan
“ ” indicator blinks dur-
ing auto memory write
scan.
IC-R5_1.qxd 02.10.23 11:29 Page 29 (1,1)
