CHAPTER
2-1
Cisco uBR-3x10 RF Switch Hardware Installation and Cabling Guide
OL-1984-06
2
Preparing for Installation
This chapter describes the site requirements for installing the Cisco uBR 3x10 RF Switch. The chapter
contains the following sections:
• Safety, page 2-2
• Site Requirements, page 2-5
• Provisioning the Headend, page 2-7
• Tools for Installation, page 2-9
• Verifying the Shipping Container Contents, page 2-11
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Warning
This equipment must be installed and maintained by service personnel as defined by AS/NZS 3260.
Incorrectly connecting this equipment to a general-purpose outlet could be hazardous. The
telecommunications lines must be disconnected 1) before unplugging the main power connector or 2)
while the housing is open, or both.
Statement 1043
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
