Appendix A. Security and QoS Configuration Messages 51
%Error:FAILURE to reinsert old ACL,
errcode=XX
This error message means that a hardware failure has
occurred.
Delete the access group, and re-enter the command that
you had entered before receiving the error message.
If the message recurs, find out more about the error by
using the show tech-support privileged EXEC command
and by copying the error message exactly as it appears on
the console or system log and entering it in the Output
Interpreter tool. Use the Bug Toolkit to look for similar
reported problems. For more information about these online
tools , see the “Error Message Traceback Reports” section
on page 9.
%Error:Egress port invalid
This error message means that an invalid egress port was
detected by the hardware.
Re-enter the command that you had entered before
receiving the error message.
If the message recurs, find out more about the error by
using the show tech-support privileged EXEC command
and by copying the error message exactly as it appears on
the console or system log and entering it in the Output
Interpreter tool. Use the Bug Toolkit to look for similar
reported problems. For more information about these online
tools , see the “Error Message Traceback Reports” section
on page 9.
%Error:The field sets of all the ACEs in
an
ACL on Ethernet interface should match.
Please
refer to the Software Configuration Guide
to
understand one mask restriction for ACLs
on
Ethernet interface
This error message means that one or more of the ACEs in
an ACL must have the same mask.
Change the ACEs to have the same mask as the other
ACEs in the ACL.
%Error:Access-list with '[keyword]'
keyword is
not supported on Ethernet Interface. The
ACL
'[acl name]' is either used as a Security
ACL
or QoS ACL. Please refer to the Software
Configuration Guide for all the supported
keywords
This error message means that the new ACE added to the
ACL contains one or more keywords that are not supported
on the Ethernet interface.
Remove any nonsupported keywords from ACL.
%Error:Access-list with '[keyword]'
keyword is
not supported on Ethernet Interface.
Please
refer to the Software Configuration Guide
for
all the supported keywords
This error message means that the ACL to be applied to a
Layer 2 interface or class-map contains one or more
keywords that are not supported.
Remove any nonsupported keywords from ACL.
Table 4. Common ACL Error Messages (Continued).
Error Message Explanation and Suggested Solution
