Filter
Top Products
(E) Symbio 160HD4
Copyright © 2004 TOSHIBA CORPORATION. All rights reserved.
9
Editing IEEE-1394 device information
in the Device Management window
IEEE-1394 device information is saved in the TV’s memory.
You can edit this information in the Device Management
window, including changing the device label, changing the
analog input information (if applicable to your IEEE-1394
device), or deleting the device information from the TV’s
memory if you no longer use that device.
Note: The Symbio AVHD recorder does not use an analog input.
To edit the device information:
1. Press MENU and then x or • to open the SETUP menu.
2. Press y or z to highlight INSTALLATION and press
ENTER. (A new set of INSTALLATION menu icons will
appear on-screen, as shown in the illustration below right).
3. Press x or • to open the DEVICES menu.
4. Press y or z to highlight IEEE-1394 DEVICES and press
ENTER.
5. Press y or z to
highlight the
device you want
to edit and press
ENTER. Follow
the on-screen
prompts.
Setting the AVHD skip time
You can skip forward or backward during playback of recorded
programs. The AVHD skip time is the amount of time the
device will skip each time you press SKIP/SEARCH
SS
|
or
|
TT
on the remote control. You can set the device skip time to 1, 3,
5, or 15 minutes.
To set the AVHD skip time:
1. Press MENU and then x or • to open SETUP menu.
2. Press y or z to highlight
AVHD SKIP TIME and
press ENTER.
3. Press y or z to select the
skip time amount (1, 3, 5,
or 15 minutes) and press
ENTER.
Configuring the Symbio AVHD recorder
3
Configuring the device
Follow these procedures to configure the Symbio AVHD
recorder with your compatible Toshiba integrated HD
television.
Note:
• See “Compatibility” on page 6 for a list of compatible TV models.
• See “Using the remote control to operate the Symbio AVHD
recorder” on page 10.
Device Initialization window
When you first connect the Symbio AVHD recorder to the TV,
the Symbio device will announce its presence to the TV and the
Device Initialization window will appear.
Labeling the device
The Device Initialization window allows you to change the label
for the Symbio device. This label displays in the TV’s
TheaterNet device list. The default device label is “Toshiba
AVHD.”
To keep the default label:
Press x or • on the remote control to highlight SAVE in
the Device Initialization window, and press ENTER.
To change the label:
1. Press x or • to highlight EDIT LABEL and press
ENTER.
2. Press yzx • to highlight the desired characters for the
label and press ENTER.
3. When done, highlight SAVE and press ENTER.
4. The Device Initialization window reappears. Highlight
SAVE and press ENTER.
Symbio(E)06_A_06-24 10/19/04, 3:01 PM9