Filter
Top Products
3
Symbio AVHD recorder 160HD4
Installation
Follow these recommendations and precautions and heed all
warnings when installing your device.
19) Always provide a minimum of 4 inches (10 cm) of space around all
sides of the device to allow proper ventilation.
20) When choosing a location for the device, take into consideration the
potential for damage to the device from moisture condensation. Read
item 33, “Moisture condensation precautions,” at right.
21) Always place the device on a level surface. Never use the device
on a shaky, vibrating, or unstable surface such as a wobbly table or
inclined stand. Before installing the device, make sure the surface
can bear the weight of the device.
22) CAUTION: Risk of personal injury or serious
equipment damage. Never place the device
in a high location. The device may fall, causing personal
injury or serious equipment damage.
23) Never place the Symbio AVHD recorder near or above other
devices that emit high levels of heat (such as audio receivers or
amplifiers). Failure to observe this precaution may cause heat from
the other components to rise over the Symbio AVHD recorder and
overheat it.
24) If you place the device near a TV, radio, or VCR, the playback picture
may become poor and the sound may be distorted, depending on the
location of said equipment. In such an event, place the device as far
away as possible from the offending equipment.
25) Never stack anything on top of the device.
26) Never cover the ventilation slots in the device’s case.
27) Never expose the device to dripping or splashing or place items such
as vases, aquariums, any other item filled with liquid, or candles on
top of the device.
28) Never place or store the device in direct sunlight; hot, humid areas;
areas subject to excessive dust, oily smoke, or vibration; or locations
with temperatures at or below 41°F (5°C). Such conditions may cause
the device to malfunction or shorten its service life.
29) Never place the device in an area where the temperature rises or
changes rapidly.
30) Always operate this device from a 120 VAC, 60 Hz power source only.
31) Never allow anything to rest on or roll over the power cord, and
never place the device where the power cord is subject to wear or
abuse.
32) Always place the device horizontally; never install it vertically.
Moisture condensation precautions
33) To prevent damage, never use the Symbio AVHD recorder
when moisture condensation appears on the device.
Read the following carefully before installing the device.
Moisture condensation can occur in the following situations:
•When you move the device from a cold or air conditioned room to a
hot, humid room.
•When you use the device in an area in which the temperature rises
or changes rapidly.
•When you place the device in an area in which cold air from an air
conditioner directly hits the device.
•When you use the device in a humid area.
Using the device when moisture condensation exists may
damage the hard disc drive and other parts, and is deemed
misuse. Toshiba is not liable for any damage or loss caused
directly or indirectly by such misuse, and any such damage is
not covered under the Symbio warranty.
If moisture condensation appears on the device, follow these
steps:
a) Unplug the device’s IEEE-1394 cable from the TV.
b) Unplug the device’s power cord from the AC outlet.
c) Place the unplugged device in a dry, non-humid area for at least
6 hours.
d) Leave the device in the dry, non-humid area, and plug the power
cord into an AC outlet.
e) Allow the device to warm up for at least 2 hours.
f) Make sure the device is not returned to an area with conditions
as described in the bulleted items above.
Handling
For better performance and safer operation of your device, follow these
recommendations and precautions.
34) WARNING: RISK OF ELECTRIC SHOCK!
Never spill liquids or push objects of any
kind into the slots in the device’s cabinet. Failure to
follow this WARNING may result in death or serious injury.
35) The top of the device may become hot during use. This is normal.
Always allow the device to cool before handling it.
36)When handling the device, always hold it horizontally.
37) Never shock or shake the device, especially during operation. Doing
so may cause malfunction.
38) Never disconnect the power cord from a wall outlet while the device
is recording or playing (unless it is an emergency). Before
disconnecting the power cord, close all AVHD functions on the TV
and make sure the REC and PLAY LEDs on the device’s front panel
are NOT illuminated. Unplugging the power cord during recording or
playback operation may cause malfunction or equipment damage.
39)For added protection of your device from lightning and power surges,
always unplug the power cord if you leave the device unattended or
unused for long periods of time.
40) Never use volatile compounds (such as insecticide) near the device,
and never leave rubber or plastic products in contact with the device
for long periods of time. Doing so may leave marks on the finish.
41)When shipping the device, it is recommended that you use the
original shipping carton and packing materials. For maximum
protection, repack the device as it was originally packed at the
factory.
(Continued on next page)
Symbio(E)_A_02-05 10/19/04, 3:03 PM3