Filter
Top Products
18
Troubleshooting
PROBLEM
The alarm does not sound
The alarm sounds at an incorrect time
Buzzer alarm is heard when waking to CD
There is no display and the CD/radio will
not play
CD skips while playing
POSSIBLE CAUSE
• The alarm was not set correctly for AM/PM
• Alarm icons are not on the display
• Date or 7-5-2 settings programmed
incorrectly
• The wrong alarm icon was on the display
• The alarm was not set correctly for AM/PM
• A CD was not inserted into the CD player
• The CD was inserted incorrectly into the
player
• The CD Player door is not closed
• There was a power failure
• The unit is disconnected from an AC outlet
• The AC outlet has no power
• The AC outlet is controlled by a wall switch
that is off
• Dirty or defective disc
• Dirty lens
REMEDY
• Check the alarm time setting
• Press one of the Alarm Buttons so that
its Indicator appears on the display
• Check and reprogram settings
• Make sure the alarm you wish to wake to
is the only Alarm icon that appears on the
display
• When waking to CD, always make sure a
CD has been inserted
• Always insert the CD with the label surface
facing out
• Push the door gently until it is completely
closed
• All alarms default to buzzer during a power
failure as long as working batteries are
inserted correctly inside the battery
compartment
• Connect to an AC outlet
• Try the unit on another outlet
• Do not use an outlet that is controlled by
a wall switch
• Check the bottom of the disc and clean
if necessary with a soft cleaning cloth,
always wipe from the center out
• Clean with a commercial lens cleaner
If you have any questions, call SDI Technologies Inc. Timex Audio Products Division Customer Service, 1-800-888-4491.