Filter
Top Products
14
Operating the Alarms (Continued)
Setting Alarm-3 for Nature Sounds
1. Press and hold the Q Alarm-3 Button until the Alarm-3 settings and Nature Sounds Indicator appear
on the display.
2. Press the
L
Reverse or S Forward Button to set the Alarm-3 time.
3. Use the A Sound Button to select a nature sound to wake to. There is a choice of four sounds:
Sound #1: Ocean Surf
Sound #2: Forest Spring
Sound #3: Rushing Brook
Sound #4: Summer Wind
4. See Note #4 in the Setting Alarm-1 section for instructions on setting the 7-5-2 alarm setting for Alarm-2.
5. After you have programmed the Alarm-3 settings, press the T Enter Button or wait ten seconds to return
to the clock display. The Alarm-3 Indicator will appear on the display, showing that the alarm is set.
Checking Your Alarm Time Settings
To check any of your alarm settings after you’ve set the alarm, press any Alarm Button twice so that the
settings appear on the display. The display will return to the standard clock display after a few seconds.
After you have checked the settings, be sure that the Alarm Indicator still appears on the display in order so
that the alarm will sound at the set time.
Turning Off the Alarms
1. After the alarm sounds, press the
F
Alarm Off/Reset Button to turn off the alarm while still maintaining
the programmed 7-5-2 alarm settings. To turn off an alarm and cancel its 7-5-2 settings, press its Alarm
Button so that its Alarm Indicator no longer appears on the display.
2. If it is not turned off, the alarm will sound for an hour before stopping. As long as an Alarm Indicator
appears on the display, the alarm will sound at the set time, according to the 7-5-2 settings.
3. To activate the snooze feature, press the G Snooze/Night-Light Bar when the alarm sounds. The alarm
will shut off for approximately ten minutes before sounding again. The feature can be repeated several times
during the one-hour snooze cycle.