Filter
Top Products
46
GB
Labeling Folders or Messages — Folder/Message/
User Name (continued)
Entering Characters
Follow the steps below when the display prompts to enter characters
(when the cursor is flashing in step 4 for labeling a folder on pages 43, or in
step 3 for labeling a message and changing the user name on pages 44 and
45 ).
To enter characters
1Press the jog lever up or down (>/.) to select the desired
character.
See the order of character sets on the next page.
2Press the jog lever (x•B) briefly to fix.
The cursor moves to the next.
3Repeat steps 1 and 2 to enter other characters.
To replace characters
When you make a mistake in entering a character or when you want to
change the name, enter again after all characters have been deleted by
pressing ERASE for more than one second or replace some of the
characters as follows.
1Place the cursor at the character you want to change.
To move the cursor back (to the left), press INDEX/BOOKMARK
briefly.
To move the cursor forward (to the right), press the jog lever (x•B)
briefly.
2Press the jog lever up or down (>/.) to select the desired
character.
To delete a character and close up the space, place the cursor at the
character you want to delete and press ERASE briefly.
3Press the jog lever (x•B) to move the cursor forward and repeat steps
1 and 2 to change other characters.
Note
You cannot insert a character into a name. You must simply replace all the
characters following the character you want to insert.