Filter
Top Products
Getting Started
5
GB
Required cords
Audio connecting cord (1) (supplied)
Black Black
White (L) White (L)
Red (R) Red (R)
When connecting the cords, be sure to match the color-
coded cord to the appropriate jacks on the components:
Black to Black, Red (right) to Red, and White (left) to
White. Be sure to make connections firmly to avoid
hum and noise.
Speaker connecting cords (2) (supplied)
Be sure to connect matching speaker terminals. If the
connections are reversed (+ to –), the sound will lack
bass.
Connecting to a component other than the
DVP-F11
• If your DVD player is equipped with a 2.1-channel
output jacks, connect the SA-F11 in the same way as
the DVP-F11.
• If your DVD player is equipped with a 5.1-channel
output jacks, connect the SA-F11 in the following
way:
– Connect the FRONT L/R of the DVD player to the
DVD IN L/R of the subwoofer.
– Connect the WOOFER OUT of the DVD player to
the SUBWOOFER IN of the subwoofer.
When you finish connecting, set the rear and center
speakers setup to “NONE.” If you cannot make this
setting, connect the DVD player to the AUX IN jacks.
• If your DVD player is equipped with a 2-channel
output jacks, connect it to the AUX IN jacks of the
SA-F11.
• If you connect a VCR to the SA-F11, connect it to the
AUX IN jack of the SA-F11.
Hook
Setting up for the DVD player
Some steps are necessary for the DVD player
depending on the TV or other componentes to be
connected.
Use the setup display to change the various settings.
For details on the setup display and TV setting, see
“Setting and Adjustments” in the instruction manual
equipped with the DVP-F11.
• To connect the player to a wide-screen TV
In the setup display, set “TV TYPE” in “SCREEN
SETUP” to “16:9” (default setting).
• To connect the player to a conventional TV
In the setup display, set “TV TYPE” in “SCREEN
SETUP” to “4:3 LETTER BOX” or “4:3 PAN SCAN.”
Setting up the speakers
Attach the supplied foot pads to the bottom of the
subwoofer and the speakers.
You can hang or install the front speakers on a wall
using hooks or nuts (commercially available).
Note
You are responsible for the proper selection and use of
mounting hardware purchased at a hardware store, and for
the proper and safe mounting of the speakers.
60 mm
Nuts
Foot pads
(+)
(–)
(+)
(–)