Filter
Top Products
27
MZ-S1
OVERALL ADJUSTMENT MODE
• Configuration of Overall Adjustment Mode
• Overall adjustment mode (title display)
: (Disc mark) At end of power supply adjustment: Outside lit
At end of electrical offset adj.: Inside lit
**
: Left side = MO overall adjustment information
F
*
: MO overall adjustment completed
1
*
: Manual adjustment exists (overall adj. not completed)
0
*
: Not adjusted
Right side = CD overall adjustment information
*
F: CD overall adjustment completed
*
1: Manual adjustment exists (overall adj. not completed)
*
0: Not adjusted
Note: Adjust the CD first, when performing adjustment.
• Electrical offset adjusting method
Caution: The electrical offset adjustment must be made with no
disc loaded.
1. Make sure that the power supply voltage is 3 V.
2. Set the test mode (see page 15).
3. Press the . or [VOL --] key to activate the overall adjustment
mode.
4. Press the
[MENU/ENTER] key on the remote commander.
5. Electrical offset adjustment is over, if the following display
appears.
• Adjustment Method of CD and MO Overall Adjustment
Mode
1. Set the test mode (see page 15).
2. Press the . or [VOL --] key to activate the overall adjust-
ment mode.
N >
key
N >
key
x
key
N >
key
.
key
Overall adjustment mode
(Title display)
CD overall
adjusting
CD overall
adjustment
OK
MO overall
adjusting
MO overall
adjustment
OK
CD overall
adjustment
NG
MO overall
adjustment
NG
All item
OK
Protect switch
ON
Protect switch
OFF
[MENU/ENTER] key
NG item exists
or
NG item exists
or
x
key
[END SEARCH] key
[Test mode $display check mode%]
Electrical
offset
adjustment
Temperature
correction
and
Power supply
adjustment
auto item feed
x
key
x
key
x
key
x
key
x
key
x
key
000 Assy**
Set LCD display
000 Assy11
Set LCD display
035 Ofst**
Set LCD display
000 OfstOK
Set LCD display
000 Assy11
Set LCD display