Filter
Top Products
Advanced Features
53
Using the Remote Control (RM –12)
The RM-12 remote control is a unique infra-red, two-way remote through which many of the
advanced features of the I-Mix are operated. The RM-12 has a three-step power button which
allows the unit to save power when not in use. Because the remote sends and receives
information, it is important to aim it at the unit while performing all commands. Note: If the
signal is not successfully transmitted, the remote will display an “IR Retry” message. Aim the
remote at the unit and the signal will be sent again. The RM –12 is effective from up to 30 feet
from the I-Mix unit and it uses four (4) AA alkaline batteries.
• To turn the I-Mix on, press the Power button twice.
• If the remote is not used for about 5 minutes, it will go into
an energy-saving mode and the display screen will go
blank.
• Press the Power button once to wake the RM-12. It will
enter a quick function mode (shown at left), in which only
the basic functions of the IM-120 are available.
• Press the power button a second time to restore the RM-12
to its normal function mode. The RM-12 will restore to the
active screen.
• Press the Power button a third time to turn off the I-Mix.
Take a moment to review the chart below, which illustrates the functions of the power button.
Using the three-step power button
RM-12 status IM-120
status
RM-12 POWER
Button
Result
Off Off Press POWER once RM-12 will turn on and enter quick function
mode.
Off Off Press POWER twice IM-120 and RM-12 will turn on.
Off On Press POWER once IM-120 will stay on and RM-12 will enter quick
function mode.
Off On Press POWER twice IM-120 will stay on and RM-12 will enter full
function mode and return to last active menu.
Off On Press POWER three
times
IM-120 and RM-12 will both turn off.
On On Press POWER once IM-120 and RM-12 will both turn off.
Quick Access Mode
Play back controls
only
Press <power> again
to enter
Full function mode
Entering
Normal Function Mode
Please wait
Processing...