Filter
Top Products
Basic Functions
Basic FunctionsBasic Functions
Basic Functions
Getting Started
Getting Started Getting Started
Getting Started
13
Making Connections
Connecting the I-Mix to your stereo system
Using standard RCA pin-type connectors
1. Connect the tape or CD input of your amplifier to the audio output of the I-Mix.
2. To record from an analog source such as a tape player or radio, connect the tape or record
output on your stereo receiver/amplifier to the audio input of the I-Mix
.
3. If your receiver has an optical /digital input - connect the optical output of your I-Mix to the
optical input of your stereo amplifier. See connection diagram above.
4. Connect the AC power cord to a standard 120VAC outlet.
Connecting the I-Mix to your PC
To connect the I-Mix to your PC, refer to the PC Link Manual included with your unit.
Powering up
The power switch on the back panel of the unit switches on the AC power supply. Once the I-Mix
is connected, turn this switch on. It is unnecessary to turn the power off using this switch unless
you are unplugging the unit from the wall outlet. Use the power button on the front of the unit to
turn the I-Mix off and on during normal use. Note: When you turn the I-Mix off using the front
panel button. it may go into a “sleep mode” to compress music which has been recorded. Press
the power button a second time to stop file compression – only the amber stand-by light is on
before you unplug or turn off the rear power switch.
Optical cable
(optional
not supplied)
1
2
AC power cord
13
4