Filter
Top Products
9
Setting up and connecting
KH 2420
GB
IE
CY
Disposal of the packaging
The packaging protects the device from transport damage. The packaging
materials are selected from the point of view of their environmental friendliness
and disposal technology and are therefore recyclable.
The recirculation of packaging into the material circuit saves on raw material
and reduces generated waste. Dispose of packaging material that is no longer
needed according to the regionally established regulations.
NOTICE
If possible preserve the device's original packaging during the warranty ►
period so that in the case of a warranty claim you can package the device
pr
operly for return.
Set-up location requirements
For safe and fault free operation of the device the set-up location must comply
with the following provisions:
Place the device on a fi rm, fl at and even surface. ■
Place the device so that the ventilation slots are not covered. ■
Do not place the device in a hot, wet or very humid location or in the vicinity ■
of fl ammable materials.
The sur
faces of furniture may contain components that can aff ect the rubber ■
feet of the device and could soften them. If necessary place a pad under the
de
vice's rubber feet.
The wall socket must be easily accessible so that, in an emergency, the plug ■
can be quickly withdrawn from the socket.
Electrical connection
Before connecting the device compare the connection data (Voltage and ■
frequency) on the rating plate with that of the mains electric source.
This data must be compatible to avoid possible damage to the device.
Make sure that the device's connection cord is not damaged and is not ■
laying over hot surfaces and/or sharp edges.
Mak
e sure that the connection cord is not tightly stretched or bent. ■
Do not allow the connection cord to hang over edges (Trip wire eff ect). ■