Filter
Top Products
After recording:
Press the
n
/:OFF button while in the stop
mode.
0
After the track number has been written
on the disc, the power will shut off auto-
matically. (For details about the TOC,
see page 20.)
To remove
the
MiniDisc:
Turn
off the power and move the OPEN
lever in the direction indicated by the arrow.
0
W
Recording from a tuner or a CD
(Manual recording)
0
Manual recordings can be started and
stopped as you like.
1
Place the unit in the recording stand-by
mode. (Perform steps 1
--
4 in the “Syn-
chro recording” section.)
2
Press the
)I1
button.
0
Recording will start.
0
To record from a CD, press the
)I1
button, and then start playback on the
equipment connected to this unit.
0
Track numbers can be created while
recording. (Page 17)
To interrupt recording:
Press the
)II
button while recording.
0
The unit will enter the recording stand-
by mode.
0
To resume recording, press the HI but-
ton again.
The track number will be increased by
one each time you interrupt a record-
ing.
Recordings
can not be made in the
following situations:
B
Recording on a playback-only MiniDisc
(commercially available music)
D
If a MiniDisc is protected against acci-
dental erasure (page 9)
about
the recording level:
B
If the recording level is too low, the play-
back sound volume may be too low to
hear well. If it is too high, the playback
sound may be greatly distorted. Since
digitally recorded CDs have a large dy-
namic range (the volume can vary tre-
mendously from very soft to extremely
loud), do not set the recording level any
higher than is necessary.
Precautions
when recording:
B
Do not jar or bump the main unit while
recording. Otherwise, the recording
may be unusable.
0
Depending on the strength and type 01
playback signal in the original record-
ing, the new recording may not begin
or pause at the correct point when in
the synchro mode. If this happens, try
making a manual recording.
Precautions when inserting a MiniDisc:
0
To insert a MiniDisc, push on the middle
of the edge of the disc while holding it
parallel to the main unit.
0
If any resistance is felt, do not try to
force the
MiniDisc
into the unit. It may
additional more problems. If resistance
is felt, remove the MiniDisc and try re-
loading it.
Notes:
l Whenever any button is pressed, the
remote control display will light for ap
proximately 7 seconds.
0
The REC button does not light.
11