Filter
Top Products
5
SPEAKERS
RIGHT
LEFT
RATED SPEAKER
IMPEDANCE ;
6 OHMS MIN.
1 2 3
Left speakerRight speaker
Black
Black
Red
Red
Left speaker
Right speaker
For the
left side
For the
right side
1 2 3
ANTENNA
FM aerial
AM loop antenna
AM
LOOP
FM
(1)
(2)
HH
HH
H Antenna connection
Connect the antenna wire to the ANTENNA jack.
(1) FM antenna
Position the FM antenna wire in the direction where the stongest signal can
be received.
(2) AM loop antenna
Position the AM loop antenna for optimum reception.
Place the AM loop antenna on a shelf, etc., or attach it to a stand or wall with
screws (not supplied).
Notes:
I Do not place the antenna on the unit. It may result in noise generation,
since the unit is equipped with digital electronics. Place the antenna
away from the unit for better reception.
I If the AM loop antenna and the FM antenna wire are placed near the AC
power cord, interference may result.
HH
HH
H Speaker connection
Connect each speaker wire to the SPEAKER terminals as shown.
Use speakers with an impedance of 6 ohms or more, as lower impedance
speakers can damage the unit.
Cautions:
I Connect the black wire to the minus (–) terminal, and the red wire to the
plus (+) terminal.
I Do not mix the right channel and left channel wiring when connecting the
speakers to the unit.
I Do not let bare speaker wires touch each other as this may damage the
amplifier and/or speakers.
Note:
I The speaker grille is not removable.
PREPARATION FOR USE
I Unplug the AC power cord from the AC outlet before connecting or
disconnecting any component.
HH
HH
H Placing the system
I Be sure to keep space between the units for ventilation.
I Keep the back and sides of this unit at least 2" (5 cm) away from the
wall.
I If any kind of magnet or an electromagnet is placed too close to the TV
set and the system, irregular color may be seen.
TV set location
I Depending on the particular location of a TV set, color variations may
be seen on the TV screen. If this happens, move the system and its
speakers away from the TV and turn off the TV set. After 15 - 30
minutes, turn on the TV again.
The TV's own demagnetising function should eliminate the variations.
However, if the color still does not look right, move the system further
away from the TV set.
Note:
I A cooling fan is built into this product to avoid heat buildup. When the
power is turned on, the cooling fan will run.
*01-21 98.6.23, 10:09 AM5