Filter
Top Products
Graphite MD13 · USB Pad Controller
13
ENGLISH
FRANÇAISDEUTSCHEESPAÑOLITALIANO
The Graphite MD13 settings for the five presets can be customized using the Graphite
Mini computer editor, which can be found on the Samson website www.samsontech.com.
Using the computer editor allows you to modify, upload, and save presets. The following
information outlines the available parameters for each control that can be adjusted.
Trigger Pads Control Change (CC):
Control Change: Sets the control change number that the Trigger Pad will transmit.
MIDI Channel: Sets the specific MIDI channel that the Trigger Pad will use to transmit
control change data.
Mode: Sets the behavior of the pad. If set to toggle, the pad acts like a switch, sending a
note on message when first pressed, and a note off message when pressed a second time.
When set to momentary, the pad sends a note on message when pressed down and a note
off message when the pad is released.
Knobs, Crossfader, and Master Encoder:
MIDI Channel: Sets the specific MIDI channel that the control will transmit. Each channel
strip (fader, knob, solo/mute and rec button) is set to a single MIDI channel.
Control Change: Sets the control change number that the control will transmit.
Transport Buttons:
MIDI Channel: Sets the MIDI channel number that the button will transmit.
Note or Control Change: Sets the button to transmit a note or control change message.
Note Number or CC#: Sets the specific note number or CC# that the button will transmit.
Mode: Sets the behavior of the button. If set to toggle, the pad acts like a switch, sending
a note on message when first pressed, and a note off message when pressed a second
time. When set to momentary, the button sends a note on message when pressed down
and a note off message when the button is released.
Editing Parameters