Roland AR-200 MP3 Player User Manual


 
4
IMPORTANT NOTES
In addition to the items listed under “USING THE UNIT
SAFELY” on page 2-3, please read and observe the
following:
Power Supply
Do not use this unit on the same power circuit with any
device that will generate line noise (such as an electric
motor or variable lighting system).
The AC adaptor will begin to generate heat after long
hours of consecutive use. This is normal, and is not a
cause for concern.
Before connecting this unit to other devices, turn off the
power to all units. This will help prevent malfunctions
and/or damage to speakers or other devices.
Placement
This device may interfere with radio and television
reception. Do not use this device in the vicinity of such
receivers.
To avoid possible breakdown, do not use the unit in a wet
area, such as an area exposed to rain or other moisture.
Maintenance
For everyday cleaning wipe the unit with a soft, dry cloth
or one that has been slightly dampened with water. To
remove stubborn dirt, use a cloth impregnated with a
mild, non-abrasive detergent. Afterwards, be sure to wipe
the unit thoroughly with a soft, dry cloth.
Never use benzine, thinners, alcohol or solvents of any
kind, to avoid the possibility of discoloration and/or
deformation.
Additional Precautions
Unfortunately, it may be impossible to restore the contents
of data that was stored DATA card once it has been lost.
Roland Corporation assumes no liability concerning such
loss of data.
Use a reasonable amount of care when using the unit’s
buttons, sliders, or other controls; and when using its jacks
and connectors. Rough handling can lead to malfunctions.
Never strike or apply strong pressure to the display.
When connecting / disconnecting all cables, grasp the
connector itself—never pull on the cable. This way you
will avoid causing shorts, or damage to the cable’s
internal elements.
To avoid disturbing your neighbors, try to keep the unit’s
volume at reasonable levels. You may prefer to use
headphones, so you do not need to be concerned about
those around you (especially when it is late at night).
When you need to transport the unit, package it in the box
(including padding) that it came in, if possible. Otherwise,
you will need to use equivalent packaging materials.
Use a cable from Roland to make the connection. If using
some other make of connection cable, please note the
following precautions.
Some connection cables contain resistors. Do not use
cables that incorporate resistors for connecting to this
unit. The use of such cables can cause the sound level
to be extremely low, or impossible to hear. For infor-
mation on cable specifications, contact the manufac-
turer of the cable.
Before Using PC Cards
Never attempt to remove a PC Card from the drive while
the drive is operating (the indicator is lit); damage could
result to both the card and the drive.
Remove any disk from the drive before powering up or
down.
To avoid the risk of malfunction and/or damage, insert
only PC Cards into the disk drive. Never insert any other
type of disk. Avoid getting paper clips, coins, or any other
foreign objects inside the drive.
Before Using Cards
Using DATA Cards
Carefully insert the PC card all the way in—until it is
firmly in place.
Copyright
Unauthorized recording, distribution, sale, lending, public
performance, broadcasting, or the like, in whole or in part,
of a work (musical composition, video, broadcast, public
performance, or the like) whose copyright is held by a
third party is prohibited by law.
Do not use this unit for purposes that could infringe on a
copyright held by a third party. Roland assumes no
responsibility whatsoever with regard to any infringe-
ments of third-party copyrights arising through your use
of this unit.
PC card
Eject button
AR-200_e.book 4ページ 2003年7月14日 月曜日 午後1時11分