Filter
Top Products
11
Installation
Rack-Mounting the AR-200
By attaching a rack mount adaptor to the AR-200 (RAD-50: sold separately) you can
install it in an EIA rack. One RAD-50 can accommodate up to two AR-200 units.
1
Remove the four rubber feet from bottom of the unit.
fig.set-02
2
Attach the RAD-50 adaptor to the AR-200 using the screws
that are supplied with the RAD-50.
fig.set-03
Attaching the Card Protector
By attaching the Card Protector (supplied) to the AR-200, you can prevent the
PC card from inadvertently being removed from the AR-200.
After confirming that the card is securely inserted in the card slot, use the
provided screws to attach the Card Protector, as shown in the figure below.
fig.set-04
Note: Do not use these holes.
RAD-50
Card Protector
AR-200_e.book 11 ページ ２００３年７月１４日 月曜日 午後１時１１分