Filter
Top Products
9
Connecting your clock radio to your computer
network
1. Place your clock radio on a fl at surface and plug the cable from the
mains adaptor into the DC input socket located on the rear of your
clock radio (marked 'DC') ensuring that the plug is pushed fully into
the socket.
2. Plug the mains adaptor into a wall socket and switch on the socket.
IMPORTANT: The mains adaptor is used as the means of connecting
the radio to the mains supply. The mains socket used for the radio
must remain accessible during normal use. In order to disconnect the
radio from the mains completely, the mains adaptor should be removed
from the mains socket outlet completely.
3. When you apply power, the display on the clock radio will light up and
say: 'Roberts Internet Radio'. If no network connection is yet confi gured,
the clock radio will now scan for all available wireless networks and
will show 'Scanning'.
4. If the clock radio cannot fi nd a network then the display will say 'No
Wireless Networks Found'. If this happens then you will have to get your
wireless access point working - please see the instructions supplied
with it.
5. When the clock radio fi nds your wireless network, it displays the
Network Name (SSID) for the access point on the screen. This is a
name that is allocated to the access point by the person who set up
the network - for example: 'My Home Network'.
6. It is possible, and in some locations highly likely, that your clock radio
will fi nd more than one wireless access point, in which case you should
choose which one you need to connect to.