Filter
Top Products
21
OPERATION
FOR NON-DOCKING iPods, OTHER MP3 PLAYERS,
AND CD PLAYERS:
Select AUX 2 MODE.
Open the drop-down compartment door by pulling up on
the latch handle.
Make sure the iPod/MP3 player will fit inside the
compartment provided.
NOTE: CD players will not fit.
The retainer strap may be used to secure the iPod/MP3
player into position.
CD players can simply be placed on the foam padding on
the inside of the compartment door. The compartment
door cannot be closed when a CD player is connected.
Connect one end of a 3.5 mm audio patch cord (maximum
8 in. long) to the iPod/MP3/CD player.
Connect the other end of the 3.5 mm patch cord to the
AUX 2 jack provided.
Make sure that the audio patch cable is positioned so
that it is not pinched if the door is closed.
The iPod/MP3/CD player must be ON and in PLAY mode
for sound to be heard through the speakers.
All iPod/MP3/CD player controls can be used normally
while connected to radio.
NOTE: Volume for any device connected through the
AUX 2 jack is adjusted using the volume control for that
device.
Turning the radio OFF will NOT turn the iPod/MP3 player
OFF.
To protect the iPod/MP3 player from environmental
hazards such as dust, moisture, etc., the drop-down
compartment door must be closed and latched.
The AUX 2 jack DOES NOT provide charging function.
For complete operating instructions for all iPod, other
MP3 players, and CD players, always refer to the manual
that was included with your model.
Most CD players are too large to fit inside the internal
compartment. To use these devices, open the drop-down
compartment door to access the AUX 2 input jack, and
connect the device as described above. Turn on the CD
player and adjust the volume to the desired level.
Fig. 24
iPod OR OTHER
MP3 PLAYER
3.5 mm AUDIO
PATCH CABLE
(INCLUDED)
LCD DISPLAYS
AUX 2 MODE
RETAINER
STRAP