Filter
Top Products
20
OPERATION
USING AN iPod WITH THE JOB-SITE RADIO/
RACE SCANNER
See Figures 22 - 24.
FOR DOCKABLE iPods (with 30-pin connector):
Select AUX 1 MODE.
Open the drop-down compartment door by pulling up on
the latch handle.
Orient the iPod face up as shown and slide the unit under
the retainer strap.
Make sure that the 30-pin connector on the iPod is aligned
with the 30 pin connector in the door and that the iPod is
pushed down completely to ensure proper docking.
The iPod must be ON and in PLAY mode for sound to be
heard through the speakers.
The iPod will recharge while playing. The iPod will
recharge when docked, even if the radio power is OFF.
All iPod controls can be used normally while the unit
is docked, with the exception of the volume. Volume
is controlled through the volume control knob on the
radio.
Turning the radio OFF while the iPod is docked will NOT
turn the iPod OFF.
To remove the iPod from the dock, simply pull upward to
disconnect.
To protect the iPod from environmental hazards such as
dust, moisture, etc., the drop-down compartment door
must be closed and latched.
For complete operating instructions for the iPod, always
refer to the manual that was included with your iPod
model.
Fig. 22
Fig. 23
LCD DISPLAYS
AUX 1 MODE
iPod
30-PIN
CONNECTORS
RETAINER
STRAP