Filter
Top Products
Additional information
14
106
En
Additional information for cable/
satellite/STB (set-top box) users
The following instructions show how to use the timer
features of your STB with this recorder.
Setting up
1 Connect the STB’s audio/video outputs to a set of
audio/video inputs on this recorder.
2 Switch on both the STB and this recorder and
switch the recorder’s input function to the STB (L1,
L2 or L3).
To check that everything is connected properly, switch on
your TV and select this recorder as the video input. You
should see whatever the STB is tuned to.
3 Program the IR controller supplied with your STB
to send start/stop recording codes for a Pioneer VCR.
See the manual that came with the STB for how to do
this.
Only the
REC
and
STOP
codes have any effect when used
with this recorder:
•
REC
– Start recording
•
STOP
– Stop recording
4 Position the IR controller so that it will control
this recorder.
The IR sensor on the recorder is located just above the
mark on the front panel.
Making a timer recording
1 Set the timer on the STB.
See the manual that came with your STB for how to do
this.
2 Switch on this recorder.
You must leave the recorder on until the recording
finishes.
• At the programmed times, the STB will start and stop
recording on this recorder.
DVR-530H_KU.book 106 ページ ２００５年６月８日 水曜日 午前１１時１６分