Filter
Top Products
24
Connect peripheral equipment
If the monitor is connected to a video recorder with the EasyLink function, in some
cases the monitor will be switched on, even when it was in standby. (E.g. playback
tape,...)
This is not possible when Child lock On is selected.
Equipment connected with an aerial cable only :
Select the programme number under which you have stored the test signal
with the digit keys.
Equipment connected to a euroconnector, to the VGA MONITOR IN
connector or to the front side of the receiver box
Press the w key repeatedly to select EXT1, EXT2,EXT3, FRONT or VGA,
according to where you connected your equipment at the back or the front
side of your receiver.
Remark : Most equipment (decoder, video recorder) carries out the switching itself.
If you want to change to TV channels?
Enter the programme number of the TV channel which you want to watch
with the digit keys.
& Select VGA with the w key.
é Press the red (picture menu), green (sound menu) or yellow (features menu)
key on the door of the remote control to switch on the
VGA menu
(or press the
MENU key on the simplified remote control).
“ Select one of the PC symbols with the cursor up/down:
H for contrast,
G for brightness,
for colour temperature,
for horizontal picture position,
for vertical picture position,
V for volume.
‘ Press the cursor left/right to alter the selected adjustment.
( Press one of the coloured keys again (or the MENU key on the simplified
remote control) to switch off the
VGA menu.
VCR 1
VCR 2
DVD
AMP
TUNER
TAPE
SAT
CD
TV
ZOOM
π
π
π
π
OK
M
w
TV
B
+
V
P
+
VGA menu
To select connected equipment