Philips MCD122 Clock Radio User Manual


 
27
disc play reaches the end and no control is
operated.
Poor radio reception
Increase the distance between the unit and
your TV or VCR.
Fully extend the FM antenna.
Connect an outdoor FM antenna instead.
Audio or subtitle languages cannot be set
The disc is not recorded with sound or
subtitles in multiple languages.
The audio or subtitle language setting is
prohibited on the disc.


device has exceeded a certain limit. This
phenomenon is not a malfunction.

supported.
USB device not supported
The USB device is incompatible with the unit.
Try another one.
Timer does not work
Set the clock correctly.
Switch on the timer.
Clock/timer setting erased
Power has been interrupted or the power
cord has been disconnected.
Reset the clock/timer.
Clean the disc.
A distorted picture may appear during
progressive scan setup.
The aspect ratio of the TV screen cannot be
changed even though you have set the TV
display format.

DVD disc.
The aspect ratio may not be changed for
some TV systems.
No sound or poor sound
Adjust the volume.
Disconnect the headphones.
Check that the speakers are connected
correctly.
Check if the stripped speaker wires are
clamped.
Remote control does not work

select the correct source with the remote
control instead of the main unit.
Reduce the distance between the remote
control and the unit.
Insert the battery with its polarities (+/–
signs) aligned as indicated.
Replace the battery.
Aim the remote control directly at the
sensor on the front of the unit.
Disc does not play
Insert a readable disc and ensure that the
label side faces up.
Check the disc type, color system and
regional code. Check for any scratches or
smudges on the disc.
Press SYSTEM MENU to exit the system
setup menu.
Disable the password for parental control
or change the rating level.
Moisture has condensed inside the system.
Remove the disc and leave the system
turned on for about an hour. Disconnect
and reconnect the AC power plug, and
then turn on the system again.
As a power-saving feature, the system
turns off automatically 15 minutes after
English
EN