Filter
Top Products
4
Connect and Charge
1. Connect the supplied multi-voltage adaptor/charger to your player by plugging it into the DC-In connector
at the bottom of the player and then plug the other end into a standard AC outlet.
2. The battery will be fully charged in 4 hours when charging it for the first time and 70% charged in 1 hour
for quick charge.
3. The player is fully charged when the charging animation stops and is displayed.
Battery level indication
The approximate power levels of your battery are indicated as follows:
Battery is full
Battery is two-thirds full
Battery is half full
Battery is low
Battery is empty
When the battery is nearly empty, the following power low warning screen will blink and emit a beep tone.
When you hear a double beep, your player will power down in less than 60 seconds. All settings and un-
finished recordings will be saved before the player shuts down.
Install
1. Insert the CD supplied with your product into the CD ROM drive of your PC.
2. Follow the onscreen instructions to complete the installation of
Windows Media Player
(including
necessary plug-ins) and
Philips Device Manager
.
3. You may need to restart your PC after software installation.
4. If the installation program does not start automatically, browse the CD contents via
Windows Explorer
and run the program by double clicking on the file ending with
.exe
.
IMPORTANT!
For US: There are two CDs and both are required for installation.